These signs include very flat primers, slightly cratered primers, ejector marks on the case head, and stiff extraction. In conjunction with these measurements, case head signs of pressure should be monitored as well. 0006”-.0007” expansion, and should be measured on the belt. 223 Remington, will show maximum pressure at. 30-30 Winchester, usually yield maximum pressures at. Firing pin impressions, extractor marks, ejector marks, and chamber marks. By placing a small mark on the case head – entering the cartridge in the chamber with mark at 12 o’clock – a consistently accurate measurement can be taken with each firing. marks left on the casing and/or bullet are caused by the lands and grooves.
EJECTOR MARKS SERIES
Measurement is taken just ahead of the extractor groove on the case head and must be taken at the same place on the case before and after firing. Outstanding example such as Glock series weapon could be reached due to the cogent proof of rectangular firing pin impression, the pointed ejector marks near to. I typically use water on my sanding stick to. Apply with a sculpting paddle, toothpick, or scrap plastic. Currently my favorite brand of putty is Tamiya Basic Type (No. This method works best on relatively shallow ejector-pin marks. Previously fired cases cannot be used accurately due to various levels of brass hardening. First up: filling the recessed mark with putty. Micrometers measuring in thousandths (.001") are insufficiently accurate to perform these measurements, and should not be used. Using a blade micrometer that measures in ten thousandths (.0001"), new, unfired cases can be gauged before and after firing to determine reasonably accurate maximum loads. There is another slick way to check for pressure signs if you are interested.
Generally this is visual observation of the fired shell case head and primer. The cautious reloader gradually works up to approved maximum loads to ensure his particular gun does not show pressure signs. Ejector marks, Toolmarks produced on the head of a cartridge case, from contact with the ejector (generally at or near the rim). One of the first rules of handloading is to always follow the approved reload data. Model: Ejector MPN: KA01600, A01600 For Gun Type: Handgun Country/Region of Manufacture: United States For Gun Model: Mark Series 1 2 3 4 & 22/45 & LITE.
0 kommentar(er)
